IR Sequence - Volume command
This sequence can be executed when control system is not in mute state.
There are two different ways to handle the volume sequence: "Continuous" and "Start/Stop". Check the manual for your device to see how it is controlled.
Remember to always fill in both the "Volume up" and "Volume down" commands.
Continuous
When using Continuous, the button is pressed and the command is sent continuously.
|
Item |
Description |
|
The time between commands... |
Defines the time between sending the first command and the second command. If the second command are not in use, this time is discharged. |
The sequence has the following function:
When key is pressed:
-
Start sending the command and repeat the sending of the command with the interval entered.
- The LED of the button start flashing.
When key is released again:
- Stop sending command.
- The LED of the button stop flashing.
Start/Stop
When using Start/Stop, the button is pressed once and the command is sent until the button is pressed again.
The sequence has the following function:
When key is pressed:
-
The first command (Start volume) is transmitted once.
- The LED of the button start flashing.
When key is released again:
- The second command (Stop volume) is transmitted once.
- The LED of the button stop flashing.