Skip to main content
Chat with Biamp tech support
Biamp Cornerstone

LAN/Serial Sequence - Power off command

This sequence can be executed when control system is on and not in mute state.

RS232/RS485 byte delay: If you need a delay between each byte sent on the RS232/RS485 port you can specify that here. This setting will take effect for only this sequence. If you need the delay for all the sequences  you can specify it in the settings for RS232/RS485. This is only an option for devices from version 2.00.

Control sequences can be assigned to a subkey on your control system, which is not possible for a source sequence.
Control sequences cannot be activated when the panel is off (as standard).
Control sequences are intended to be used for functions like: Play, Pause, Stop, Forward etc.

Item  Description

The time between commands...

Defines the time between sending the first command and the second command. If the second command are not in use, this time is discharged.

The cool down time...

Defines the time from sending the last command in the sequence until the device is ready to power on again.
Please note that setting this time too low can prevent the "power on" sequence from working as intended.


The sequence has the following function:

When key is pressed:

  1. The LED on the button start flashing.
  2. First power off command is sent.
  3. Wait "Time between commands..." (if second command is available).
  4. Second power off command is sent. (If available).
  5. Wait "The cool down time...".
  6. The LED's turns into power off state.

When key is released again:

  1. Nothing.
  • Was this article helpful?