Evoko Kleeo Firmware
This article explains how to update or reset the firmware of the Evoko Kleeo.
Updating firmware
The latest available firmware update can be installed using the Devices page of the Biamp Workplace admin portal. Additionally, a Kleeo automatically installs the most recent firmware update when it is assigned and connected to a Biamp Workplace organization.
Resetting
Resetting a Kleeo removes all configuration from the device and returns it to its out-of-box state.
-
Remove the housing of the Kleeo unit by sliding it backwards to expose the pin-hole reset button.
-
The pin-hole reset button is located near the bottom-right corner of the back of the Kleeo.
-
-
Insert a paperclip into the pin-hole. You should feel the reset button being pressed.
-
After a few seconds, the Status LEDs will flash three times.
-
Remove the paperclip from the pin-hole and allow the reset process to complete.
Once the Kleeo is reset, you will need to reconnect it to Biamp Workplace.