Skip to main content
Chat with Biamp tech support
Biamp Cornerstone

Using Microsoft Edge with GUI enabled Impera Control systems and extensions

As Microsoft as per 15th of June 2022, has terminated support for their Internet Explorer browser there is a compatibility issue with the Impera control systems and Biamp extensions that uses a web based GUI. 

Fortunately Microsoft has made a special mode in their browser successor Microsoft Edge called IE Mode. This mode will launch the webpage using the legacy IE based engine. 

See a guide here on how to enable IE mode in Microsoft Edge. 

 

Connecting by LAN

After it has been enabled simply navigate to:

http://<impera_ip> or http://<extension_ip>  and go to Settings (ooo) > Reload page in Internet Explorer mode.

clipboard_e965151e1e4bd3e84ea802d58743155a9.png

 

Accessing Multiple GUI's via web browser

Here is how to access the controller through a browser. Biamp recommends the use of Microsoft Edge in IE Mode in Windows or Safari on a Mac. 

Open a new tab and simply enter the IP address of the controller, e.g. 192.168.10.100. 

If you are using the multiple graphical interfaces function, you will need to enter a bit more than just the IP address.

The five different address you need is as follows: (# = IP address)

http://###.###.###.###/pages.html?id=1

http://###.###.###.###/pages.html?id=2 

http://###.###.###.###/pages.html?id=3

http://###.###.###.###/pages.html?id=4

http://###.###.###.###/pages.html?id=5

Connecting by USB

NOTE: If connecting to the product using USB and the virtual LAN adaptor driver 'Neets Control RNDIS' you can use one of these as the URL:

http://192.168.0.4 or http://neetsweb and go to Settings (ooo) > Reload page in Internet Explorer mode.

clipboard_e965151e1e4bd3e84ea802d58743155a9.png

If no RNDIS driver is shown in Device Manager > Network adaptors, check this article for a solution: