Configuring GoToMeeting for use with Devio
In most cases, you should be able to connect the Devio to your computer, launch the soft codec of your choice, and the soft codec will automatically utilize Devio for all conference audio. However, it is sometimes necessary to manually configure a soft codec to use Devio, rather than its existing default audio device. This article will demonstrate how to configure this when needed.
Ensuring the computer recognizes Devio properly
When the Devio is connected to a computer via USB, it will enumerate as a speakerphone. This means that it will provide both a microphone and loudspeaker to the computer.
If you wish to confirm that Devio has connected and enumerated properly, you can open the sound properties for the computer using one of the methods below:
Windows
- Right-click on the speaker icon on the Start bar, then select Sounds
- In the Sound dialog that will appear, check under both the Playback and Recording tabs
- Confirm that the Devio is listed in both of these places, and that it enumerates as a speakerphone
- In each of these places, select the Devio entry and click on "Set Default," then press OK to apply
- If the Devio does not appear properly, try the following:
- Ensure that your USB drivers are up to date
- Disconnect and reconnect the USB cable entering the computer from the Devio
- Power cycle the Devio
- Reboot the computer
Selecting Devio in GoToMeeting
- Under the Options section of your GoToMeeting window, select Computer Audio.
- Under both the microphone and speaker setting drop-downs, select "Echo Cancelling Speakerphone (Devio USB Audio)".
- Click on Sound Check to verify both microphone and speaker audio are functioning as intended.
