Netgear M4250 - Enabling AVB using the Command Line Interface (CLI)
This article outlines the commands used to enable AVB using the Command Line Interface (CLI). You must first activate the AVB license before executing the commands listed below.
CLI Commands
User:admin
Password:********
(M4250-26G4F-PoE+)>en
(M4250-26G4F-PoE+)#configure
(M4250-26G4F-PoE+)(Config)#mvrp
(M4250-26G4F-PoE+)(Config)#no port-channel auto
(M4250-26G4F-PoE+)(Config)#no switchport mode auto
(M4250-26G4F-PoE+)(Config)#classofservice trust dot1p
(M4250-26G4F-PoE+)(Config)#dot1as
(M4250-26G4F-PoE+)(Config)#mmrp
(M4250-26G4F-PoE+)(Config)#msrp
(M4250-26G4F-PoE+)(Config)#msrp max-fan-in-ports 30
(M4250-26G4F-PoE+)(Config)#interface 0/1-0/30
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#mtu 1500
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#dot1as
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#mvrp
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#mmrp
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#msrp
(M4250-26G4F-PoE+)(Interface 0/1-0/30)#exit
(M4250-26G4F-PoE+)(Config)#exit
(M4250-26G4F-PoE+)#save
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Config file 'startup-config' created successfully.
Configuration Saved!
(M4250-26G4F-PoE+)#