VoIP
Overview
Learn how to integrate Biamp’s VoIP-2 card with any SIP-based VoIP system.
Background
Biamp’s VoIP-2 card allows Biamp AudiaFLEX digital signal processors to make and receive phone calls over any Voice-over-IP (VoIP) system that adheres to the SIP (Session Initiation Protocol) standard. Biamp has conducted internal testing of VoIP-2 cards with the following VoIP systems:
- Cisco CallManager
- Avaya Session Manager
- Avaya SIP Enablement Services (SES)
- Avaya IP Office
- Shoretel
- Mitel 3300 ICP
Articles
- Avaya IP Office configuration for Audia VoIP-2
- Avaya Session Manager configuration for Audia VoIP-2
- Avaya SES configuration for Audia VoIP-2
- Cisco CallManager configuration for Audia VoIP-2
- DiffServ to ToS conversion table
- Mitel 3300 ICP configuration for Audia VoIP-2
- Audia-Nexia Performing a Wireshark trace of a Biamp VoIP device
- Audia-Nexia Reading a Wireshark trace of a Biamp VoIP device
- Shoretel VoIP configuration for Audia VoIP-2
- VoIP-2 card
- VoIP-2 status messages
Settings checklist
Use the pdf form linked below to record the settings you'll need to successfully deploy a Biamp VoIP installation. The administrator for the VoIP system can assist you in gathering all of the information you need.
Note that the VoIP-2 card does not allow the use of fully qualified addresses, you must configure the system to allow the extension to register using an IP address. (Example: for the VoIP-2 Proxy Username - Room1234@phone.com is not allowed, Room1234 is allowed.)